IVM 4
SPC 4 - ESSENTIALS
© AKG Acoustics 2008
SPC 4: SETUP
Headline
Cascaded SPC 4 Setup:
Single-stage cascaded SPC 4
Power only the SPC 4!
(Power for SST not needed)
Use the PSU4000 to power IVM
and WMS Systems!
NOTE: AKG recommends to use one SPC 4 / one antenna per 4 channels SST 4!
Contact your local AKG dealer before using a single-stage cascaded SPC 4!
SPC 4: Multichannel Conditions
Headline
RF Power Level at SST 4
10mW
20mw
50mW 100mW
No. of channels
1
2
3
4
5
NOTE: AKG recommends to use only single SPC 4 setups!
6
7
8
9
10
11
12
13
14
15
16
... Possible
... Please contact your local AKG dealer
... Not possible
5
SPC 4: KEEP IN MIND!
ꢀ Use only passive AKG antennas with SPC 4: SRA2W or RA4000W
ꢀ Use short cable lengths between SPC 4 and antenna: Maximum is 10m for a RG58 cable
ꢀ Set SST 4 RF output power according to slide: ‘SPC 4 Multichannel Conditions’
ꢀ All connected SST 4 transmitters should operate in the same frequency band
ꢀ LED Status
ꢁ Green: System is working fine
ꢁ Red: The antenna combiner has overheated or no AKG antenna is connected. The
internal amplifier shuts down in both cases.
ꢀ The SPC4 has two power supply jacks
ꢁ One to power the SPC 4: labeled DC ONLY- 12V/1.4A - SPC4
ꢁ One to power all connected SST 4: labeled DC ONLY – 12V/2A – SST Power Supply
ꢀ If you are NOT using the PSU 4000
ꢁ Power the SPC 4 with the CU 4000 power supply (AC-CU4000, 1.4A)
ꢁ Power all connected SST 4 separately with the provided power supply (AC12, 500mA)
|
Abbingdon Music Research CD Player CD 77 User Manual
Abocom Switch SW2400M User Manual
Acer Computer Monitor P193 User Manual
ADTRAN Network Card 6540 SHDSL User Manual
Air King Electric Heater 3LY41 8540 User Manual
Airlink101 Security Camera AIC1620W User Manual
Alesis Music Mixer i02 User Manual
Atmel Electronic Keyboard 08PIA DK User Manual
Audiovox Automobile Electronics PRO PDA15 User Manual
Axis Communications Security Camera 209FD FD R User Manual